More actions
Do not use the Roland unless you have had Roland Printer Training. This is just a checklist.
Prep file
- open in CorelDraw
- set the vector that is the cut-out for the decal and backing to Contour cut
- set the vector that is the cut for the decal on top of the backing to Perf contour cut
- save as .pdf file with your name as part of the file name
Setting up roll of vinyl
- see details in instructions on the bucket
- make sure rollers are up
- push through media until 1 beep and then 2 beeps; fan should come on to hold it down
- lower rollers
- slide the side clamps onto the vinyl until the edge shows in the holes
- click "setup" button on screen on Roland
- click the material you are using (if not plain shiny vinyl, check the canonical instructions, wherever they are)
- it should say ready to print or something similar after that
Sending the print job
- open VersaWorks on the Roland PC
- drag the .pdf file into the file list on the left
- click the printer button
- the PC will take some time to process and print the file
Shut-down
- lift the rollers
- wind the vinyl back onto the roll
for all |
Just a note from using it today. I could not find any instructions for it around to remind me of the details. Ttenbergen (talk) 23:18, 2024 October 27 (CDT) |