Instructions:Double Bevel Sliding Compound Miter Saw

Purpose

The miter saw can cut across material, with the ability to tilt in two axes and slide back and forth for deep cuts.

Do:

Use clamps and fixtures for small or awkward workpieces
Use the appropriate throat plate so that material does not become trapped (zero clearance between blade and throat plate)
Lock the miter slider when cutting across small workpieces
Use an appropriate blade for the task

Do not:

Cut wood thin into slices that are small enough to fall between blade and clearance slot edges (thinner than ¼”)
Put hands in the “no hands zone” indicated by stickers on the base
Stand directly behind the blade when cutting
Use the zero-clearance plate for anything other than 90 degree (straight up and down/perpendicular) cuts

Releasing the trigger will apply the brake to the saw and stop the blade.

Ensure correct throat plate is installed:
1. Zero clearance MDF plate for 90 degree (no bevel or miter) cuts
2. Factory throat plate for bevel cuts (anything other than 90 degrees)
Check under the throat plate for trapped debris.
Hold the workpiece securely against the fence. If the workpiece is too small or oddly shaped to hold safely, use clamps to secure it to the fence.
Press and hold the trigger and safety interlock.
Pull the saw towards the operator and lower the blade.
Using consistent speed and pressure, push the blade into the workpiece.
At the end of the cut with the blade still lowered, release the trigger and wait for the blade to stop.
Lift the blade and remove the workpiece.

for all	Please fill out this section. Probably involves a wrench and maybe a blade stop of some sort? People are loosening screws that they don't need to be loosening, so make sure you've been shown how to do it properly.

All workpieces and fixtures have been removed from the table
Dust extractor tube has been removed and checked for debris/clogs
Throat plate has been checked for trapped debris that could be launched at the next user (use a flashlight to check under throat plate, remove plate for cleaning if necessary)
Table, fence, handles have been wiped with brush
Floor around miter saw, band saw, table saw has been swept