Eye Wash Station

Whatever is discussed in here likely also applies to Fire Extinguisher.

for all

Doug pointed out that we may not have good documentation on these, let's change that. Here is a start... This should contain instructions on how to use the eye wash stations. It should probably also include whom to notify, and a link to the incident form, since use of a wash station would warrant a form. Maybe the form is how we find out that they were used, too. As much as that is internal info, I think it might also be good to add if we have spares on hand, and possibly where we get them.

• Cargo

• Categories

for all

We'll either need to find a way to link this to most rooms, or better yet, make it eye hazard dependent and link it that way... TT needs to think about this some more. Rooms and locations listed for convenience, there's probably a better way to do this in terms of the Wiki. John has also taken photos of the locations in case that's helpful later.

• Cargo

• Categories

North Forge supplies eye wash stations for use in case of eye irritation. If you use the eye wash station, please fill out an Incident Report Form.

Use

1. Remove the lid
2. If only one eye is affected, tilt your head so that the affected eye is lower. This prevents contaminants from being washed into the unaffected eye.
3. Hold the bottle against your face over the eye and squeeze.
4. While squeezing, move your eyeball around to access as much of the surface as possible.
5. If necessary, also raise your eyelids using a finger to dislodge any contaminants under the eyeball.

Locations

1st Floor Design Space

• Beside the door leading to the metalworking area/back lane (to the left when facing the door)

Metalworking Room

• On the wall beside the main entrance door by the air tank (to the left when facing the door)
• On the wall to the right of the metal lathe

3rd Floor

General Assembly Area:

• On the wall between the IoT Innovation Lab and the 3D printing room
• On the wall outside the tool room (to the right of the door)
• Inside Tiny Maker Mind workshop, on the wall opposite the door (member-owned space, do not enter except in case of emergency)
• To the right of the back elevator/directly across from the paint booth
• On the wall directly beside the main entrance (to the left when facing the door)

CNC Woodworking Room

• On the wall directly beside the door (to the right when fcing the door)

Woodworking Room

• On the wall directly beside the door (to the right when facing the door)

Epoxy Room

• On the wall directly beside the door (to the right when facing the door

Laser Room

• On the wall directly beside the door (to the right when facing the door)

3D Printing Room

• Inside the room on the wall directly beside the door (to the right when facing the door).

IoT Innovation Lab

• Inside the room on the wall beside the door (to the left when facing the door).