Instructions:Roland TrueVIS VG3-540 Printer: Difference between revisions

Latest revision as of 16:41, 2024 October 28

Do not use the Roland unless you have had Roland Printer Training. This is just a checklist.

open in CorelDraw
set the vector that is the cut-out for the decal and backing to Contour cut
set the vector that is the cut for the decal on top of the backing to Perf contour cut
save as .pdf file with your name as part of the file name

see details in instructions on the bucket
make sure rollers are up
push through media until 1 beep and then 2 beeps; fan should come on to hold it down
lower rollers
slide the side clamps onto the vinyl until the edge shows in the holes
click "setup" button on screen on Roland
click the material you are using (if not plain shiny vinyl, check the canonical instructions, wherever they are)
it should say ready to print or something similar after that

for all	Just a note from using it today. I could not find any instructions for it around to remind me of the details. Ttenbergen (talk) 23:18, 2024 October 27 (CDT)

@@ Line 5: / Line 5: @@
 * set the vector that is the cut-out for the decal and backing to Contour cut
 * set the vector that is the cut for the decal on top of the backing to Perf contour cut
-* save as .pdf file
+* save as .pdf file with your name as part of the file name
 == Setting up roll of vinyl ==