More actions
Ttenbergen (talk | contribs) Created page with "'''Do not use the Roland unless you have had Roland Printer Training. ''' This is just a checklist. == Prep file == * open in CorelDraw * set the vector that is the cut-out for the decal and backing to Contour cut * set the vector that is the cut for the decal on top of the backing to Perf contour cut * save as .pdf file == Setting up roll of vinyl == * see details in instructions on the bucket * make sure rollers are up * push through media until 1 beep and th..." |
Ttenbergen (talk | contribs) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 5: | Line 5: | ||
* set the vector that is the cut-out for the decal and backing to Contour cut | * set the vector that is the cut-out for the decal and backing to Contour cut | ||
* set the vector that is the cut for the decal on top of the backing to Perf contour cut | * set the vector that is the cut for the decal on top of the backing to Perf contour cut | ||
* save as .pdf file | * save as .pdf file with your name as part of the file name | ||
== Setting up roll of vinyl == | == Setting up roll of vinyl == | ||
| Line 23: | Line 23: | ||
* the PC will take some time to process and print the file | * the PC will take some time to process and print the file | ||
== Shut-down == | |||
* lift the rollers | |||
* wind the vinyl back onto the roll | |||
{{Discuss | | {{Discuss | | ||
Just a note from using it today. I could not find any instructions for it around to remind me of the details. [[User:Ttenbergen|Ttenbergen]] ([[User talk:Ttenbergen|talk]]) 23:18, 2024 October 27 (CDT) | Just a note from using it today. I could not find any instructions for it around to remind me of the details. [[User:Ttenbergen|Ttenbergen]] ([[User talk:Ttenbergen|talk]]) 23:18, 2024 October 27 (CDT) | ||
}} | }} | ||
Latest revision as of 16:41, 2024 October 28
Do not use the Roland unless you have had Roland Printer Training. This is just a checklist.
Prep file[edit | edit source]
- open in CorelDraw
- set the vector that is the cut-out for the decal and backing to Contour cut
- set the vector that is the cut for the decal on top of the backing to Perf contour cut
- save as .pdf file with your name as part of the file name
Setting up roll of vinyl[edit | edit source]
- see details in instructions on the bucket
- make sure rollers are up
- push through media until 1 beep and then 2 beeps; fan should come on to hold it down
- lower rollers
- slide the side clamps onto the vinyl until the edge shows in the holes
- click "setup" button on screen on Roland
- click the material you are using (if not plain shiny vinyl, check the canonical instructions, wherever they are)
- it should say ready to print or something similar after that
Sending the print job[edit | edit source]
- open VersaWorks on the Roland PC
- drag the .pdf file into the file list on the left
- click the printer button
- the PC will take some time to process and print the file
Shut-down[edit | edit source]
- lift the rollers
- wind the vinyl back onto the roll
for all |
Just a note from using it today. I could not find any instructions for it around to remind me of the details. Ttenbergen (talk) 23:18, 2024 October 27 (CDT) |