North Forge:Job Hazard Analysis

This page is about how we do a Job Hazard Analysis for a tool or SDS. See North Forge:Hazard for how this is encoded on the wiki. This data should feed into North Forge:Safe Work Procedures that need to address the hazards.

Why?

The Job Hazard Analysis is a component of the North Forge:Workplace Safety and Health Program. It is intended to satisfy the requirement for the identification of existing and potential dangers to workers at the workplace and the measures that will be taken to reduce, eliminate or control those dangers, including procedures to be followed in an emergency required by the Workplace Safety and Health Act and Regulations7.4(5)(b) and as a component of the North Forge:MadeSafe audit.

How?

• North Forge:Tool pages:
  • Step through the use of a tool following one of the following resources
    • https://www.safemanitoba.com/Resources/Pages/bulletin-249-1.aspx
  • Create or edit the relevant Tools page
  • Apply as many instances of Template:Hazard using the form as needed
  • Save
• North Forge:SDS
  • Review the cautions on an SDS Sheet
  • Create or edit the relevant SDS page
  • Apply as many instances of Template:Hazard using the form as needed
  • Save

Status

for all

Tina once North Forge:Hazard is implemented, add a query here to show the tools and sdss that have hazards, how many, and when last edited. Ttenbergen (talk) 11:15, 2024 October 15 (CDT)

• Cargo

• Categories