More actions
Poop Management
The Bambu P1S produces filament waste ("poop") that is ejected through a hole in the back. Accordingly, we have installed Poop Chutes to direct and collect the waste. Please empty the poop after each print.
As an experiment, North Forge is collecting ABS and PETG poop for recycling. There are two labelled buckets for poop. Please sort your poops into the appropriate bucket. The buckets are for poop and stringers only (not failed prints or other large clumps of waste).
Build Plates
The Bambu printers can use different build plates for different filament types. Note that some build plates require a glue stick for proper adhesion; if you use a glue stick, please clean the plate with soap and water when you are done. Do not use isopropyl alcohol or solvents on the build plates.
Textured PEI Plate
The textured PEI plate is used for PLA, ABS, and PETG. It leaves a textured surface on the bottom of prints. Typically you will not need to use a glue stick, however if you're printing with PETG it can help protect the bed.
Engineering/Cool Plate
The engineering/cool plate is a double-sided plate. The cool side is designed specifically for PLA, though you can also use it for PETG. The engineering side is used for exotic engineering materials like ABS, TPU, PA, and Polycarbonate. Glue is strongly recommended for both the engineering side and the cool side.