|
|
| Model |
PL-1340E-1.0 |
|---|
| Room |
Metalworking Room |
|---|
| Work envelope/max capacity |
- Distance Between Centers (In.): 40"
- Leadscrew Thread Pitch: 8 T.P.I.
- Length of Gap: 5"
- Spindle Bore: 1.50"
- Spindle Diameter: 1.65"
- Spindle Taper: Morse #3
- Spindle Travel: 4.5"
|
| Link to manual |
|
| Related tools |
|
| Trainer(s) |
|
| Training Sessions |
|
| Knowledge keeper(s) |
John Hache |
| Training document(s) |
|
| Material Safety Data Sheet (MSDS) |
|
| Safe Work Procedure |
|
| Consumables |
|
| Software |
this machine has no software listed |
| Equipment type |
tool |
| Metalworking Room Precautions apply
|
|
You will be working in the Metalworking Room . In order to keep safe from hazards created by you or other workers using any of the tools in this room, the following precautions apply in addition to any other precautions:
Housekeeping
|
edit these instructions at Instructions:Baileigh Lathe
Safety
Hazards
Entanglement hazard: getting sucked into the lathe will result in death or dismemberment. Do not:
- Wear loose hair, clothing, jewellery, earbuds, etc. NO HOODIES OR GLOVES. TIE BACK long sleeves.
- Reach over the chuck while the spindle is running
- Clear chips, change tools, or measure parts while the spindle is running
- Use the equipment if you're tired, distracted, intoxicated, or otherwise impaired
Projectile hazard: objects and chips being thrown by the lathe. Do not:
- Operate without wearing safety glasses
- Leave parts or tools on the headstock, tailstock, or carriage
- Operate the lathe if the part or the chuck is not properly secured
- Leave chuck keys in the chuck when starting the lathe
- Take excessively deep/aggressive cuts
- Use automatic feed when close to the chuck
Laceration hazard: sharp parts and tools. Do not:
- Clear chips with bare hands
- Handle sharp tools or parts carelessly
Safety features
- Emergency stop
- Foot brake
- Interlocked chuck cover
- Spring-loaded chuck key
- Chip guards
Housekeeping and Tool Care
- Board to protect ways when changing chuck
- Not using compressed air to clean
- Protecting ways with drop cloth when sanding
- Wipe ways before starting due to grinding dust?
- Cleaning chips when done: nothing on carriage or ways, empty chip tray when a layer of chips has formed on the bottom
The Baileigh Lathe is used to remove material from spinning objects. The workpiece spins while the tool is moved around the object to remove material. It can be used to make pins, threads, tapers, and generally a wide variety of (usually) round parts. THIS IS AN EXTREMELY DANGEROUS PIECE OF EQUIPMENT. DO NOT USE WITHOUT TRAINING AND EXTENSIVE PLANNING.
