More actions
John Hache (talk | contribs) Figuring out how instructions tab works |
Ttenbergen (talk | contribs) m Ttenbergen moved page Instructions:20" Drill Press to Instructions:20in Drill Press without leaving a redirect: Text replacement - "20" Drill Press" to "20in Drill Press" |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
== Purpose == | == Purpose == | ||
The drill press is used for drilling holes. Fences and stops can help make cuts safer and more precise. | The drill press is used for drilling holes. Fences and stops can help make cuts safer and more precise. | ||
| Line 19: | Line 18: | ||
== Operating Procedure == | == Operating Procedure == | ||
# Set the table height: | # Set the table height: | ||
## Consider the height of your sacrificial surface, drilled material and drill bit | |||
## Unlock the table lock | ## Unlock the table lock | ||
## Crank the handle to change the height | ## Crank the handle to change the height | ||
## Securely lock the table | ## Securely lock the table | ||
# If drilling completely through the material, install a waste board to protect the table. | # If drilling completely through the material, install a waste board to protect the table. | ||
# Clamp the workpiece to the table. Never hold workpieces by hand when drilling. | # Clamp the workpiece to the table. Never hold workpieces by hand when drilling. | ||
# Install the drill bit in the chuck | |||
# Set the speed range: large tool = SLOW, small tool = FAST | |||
# Using the feed handle, carefully press the bit into the workpiece. | # Using the feed handle, carefully press the bit into the workpiece. | ||
# When drilling deep holes (more than 2x the diameter of the drill bit), raise the bit periodically to clear chips. | # When drilling deep holes (more than 2x the diameter of the drill bit), raise the bit periodically to clear chips. | ||
Latest revision as of 10:51, 2024 July 23
Purpose[edit | edit source]
The drill press is used for drilling holes. Fences and stops can help make cuts safer and more precise.
Safety[edit | edit source]
Do:
- Use clamps, fences, and fixtures to hold the workpiece
- Make sure the table is locked in place before starting
- Use a sacrificial board when drilling through the workpiece
Do not:
- Hold workpieces by hand when drilling - the bit can lift and spin the workpiece, causing injury
- Drill into the table surface or communal jigs
Emergency Stop[edit | edit source]
The drill press can be stopped with the power switch.
Operating Procedure[edit | edit source]
- Set the table height:
- Consider the height of your sacrificial surface, drilled material and drill bit
- Unlock the table lock
- Crank the handle to change the height
- Securely lock the table
- If drilling completely through the material, install a waste board to protect the table.
- Clamp the workpiece to the table. Never hold workpieces by hand when drilling.
- Install the drill bit in the chuck
- Set the speed range: large tool = SLOW, small tool = FAST
- Using the feed handle, carefully press the bit into the workpiece.
- When drilling deep holes (more than 2x the diameter of the drill bit), raise the bit periodically to clear chips.
Shutdown and Housekeeping[edit | edit source]
- Remove all workpieces, tools, and fixtures
- Store drill bits in their proper spot, organized according to size
- Make sure the chuck key is stored in the holder on the side of the drill press
- Wipe down table, handles, switches with a brush or rag
- Sweep floor around the drill press and work table