Editing Instructions:Double Bevel Sliding Compound Miter Saw


== Purpose ==
The miter saw can cut across material, with the ability to tilt in two axes and slide back and forth for deep cuts.

== Safety ==
'''Do''':

* Use clamps and fixtures for small or awkward workpieces
* Use the appropriate throat plate so that material does not become trapped (zero clearance between blade and throat plate)
* Lock the miter slider when cutting across small workpieces
* Use an appropriate blade for the task

'''Do not:'''

* Cut wood thin into slices that are small enough to fall between blade and clearance slot edges (thinner than ¼”)
* Put hands in the “no hands zone” indicated by stickers on the base
* Stand directly behind the blade when cutting
* Use the zero-clearance plate for anything other than 90 degree (straight up and down/perpendicular) cuts

=== Emergency Stop ===
Releasing the trigger will apply the brake to the saw and stop the blade.

== Operating Procedure ==

# Ensure correct throat plate is installed:
## Zero clearance MDF plate for 90 degree (no bevel or miter) cuts
## Factory throat plate for bevel cuts (anything other than 90 degrees)
# Check under the throat plate for trapped debris.
# Hold the workpiece securely against the fence. If the workpiece is too small or oddly shaped to hold safely, use clamps to secure it to the fence.
# Press and hold the trigger and safety interlock.
# Pull the saw towards the operator and lower the blade.
# Using consistent speed and pressure, push the blade into the workpiece.
# At the end of the cut with the blade still lowered, release the trigger and wait for the blade to stop.
# Lift the blade and remove the workpiece.

== Blade Change ==
{{Discuss|Please fill out this section. Probably involves a wrench and maybe a blade stop of some sort? People are loosening screws that they don't need to be loosening, so make sure you've been shown how to do it properly.
}}

== Shutdown and Housekeeping ==

* All workpieces and fixtures have been removed from the table
* Dust extractor tube has been removed and checked for debris/clogs
* Throat plate has been checked for trapped debris that could be launched at the next user (use a flashlight to check under throat plate, remove plate for cleaning if necessary)
* Table, fence, handles have been wiped with brush
* Floor around miter saw, band saw, table saw has been swept