Editing Instructions:Sawstop Industrial Cabinet Saw (section)

==Shutdown and Housekeeping==
*Remove all workpieces and fixtures (feather boards, sleds, clamps) store them in their proper spots
*Return the  blade to the 90 degree (upright) position and lower it below the top of the saw
*Reinstall the riving knife and splitter if you have removed them {{Discuss | Do we have a splitter? If not, remove? }}
*Check the motor housing and dust extractor tubes for dust:
**Open the side panel and vacuum out the motor housing; close the panel and run the saw briefly to confirm interlocks are closed
**Disconnect the dust tube to check for clogs, reattach the tube
*Wipe the table, fence, handles with a brush
*Sweep the floor around the table saw, band saw, miter saw, router table.