Editing Instructions:Large Finishing Tumbler (section)

== '''Troubleshooting:''' ==

{| class="wikitable"

|'''Issue'''

|'''Possible Cause'''

|'''Possible Solution''' 

|-

|Water not flowing into tank

|Pump Motor Plugged

|Remove pump inlet filter, and unscrew the plastic housing (3 screws). 

​

Remove the housing and clean any residue that may be causing the pump not to spin.

{{Discuss | 

* we don't generally allow member maintenance; does the fablab approve this exception}}

​

Reinstall housing and test

|-

|

|Outflow pipe clogged

|The water outflows out of several small holes in the pipe. These holes are indicated with black lines. Use a screwdriver or pointed tool to clean the holes out.

|-

|Machine not turning on

|Breaker is tripped

|Reset the breaker at the pane, in the rented spaces near the machining area

{{Discuss | 

* is this a common problem? If so we need to address that. And we need more detailed instructions on which braker. 

}}

|-

|

|Motor is overheated

|Allow to cool for 30 minutes and try again

{{Discuss | 

* is this a common problem? If so we need to address that. 

}}

|}

​