Editing Instructions:Sawstop Industrial Cabinet Saw (section)

==Operating Procedure==
#Turn on the main power switch (small toggle switch).
#Prepare any safety devices that are required for a safe cut (sleds, push blocks, featherboards, outfeed table, etc)
#Test the material against the SawStop system.
#Set the blade height - typically ¼” above the top of the material.
#Turn on the blade by pulling the large red paddle button towards the operator.
#Stand to one side of the material to avoid kickback. Ensure no other people are in front of or behind the material.
#Proceed with the cut in a careful and controlled manner. With the left hand, push down on the workpiece and forward towards the blade. With the right hand, feed the workpiece forward. Do not push down with the right hand until the cut has started as kickback can occur.
#Once the cut has started, press down with the right hand.
#When the cut is complete, turn off the blade by pressing the large red paddle button.
[[File:TableSawDangerZone.jpg|thumb|400x400px|left]]
<div style="clear: both"></div>
[[File:PushDirection.jpg|thumb|400x400px|left]]
<div style="clear: both"></div>