Editing Instructions:ShopBot 3-Axis CNC Mill (section)

=== Shutdown ===
1. Turn off the dust collector. Empty it if the dust is more than halfway up the viewing window.

[[File:Nf37duston40dustoff.jpg|thumb|200x200px|left|Turn off the dust collector]]
<div style="clear: both"></div>

2. Shut down the vacuum table.
*Open all valves
*Wait 5 minutes for the motor to cool
*Shut off using the remote outside the room

[[File:Nf41vacuumoff.jpg|thumb|200x200px|left|Open bypass valve, wait, then turn off the vacuum.]]
<div style="clear: both"></div>

3. Remove the tool from the head.
[[File:Nf21loadup.jpg|thumb|200x200px|left|Remove the tool]]
<div style="clear: both"></div>

4. Move the head to the front of the bed.
[[File:Nf9arrow.jpg|thumb|200x200px|left|Move the head to the front of the bed]]
<div style="clear: both"></div>

5. Install the rest block under the head.
*Make sure the skirt isn't resting on the support block.
[[File:Nf43restblock.jpg|thumb|200x200px|left|Install the rest block]]
<div style="clear: both"></div>

7. Turn off the power.
[[File:Nf46poweroff.jpg|thumb|200x200px|left|Turn off the power]]
<div style="clear: both"></div>

8. Turn off the air.
*The head will slowly sink downwards onto the rest block.
*Press gently on the head if the tool does not sink.
[[File:Nf47airoff.jpg|thumb|200x200px|left|Turn off the air]]
<div style="clear: both"></div>

9. Press the E-STOP.
[[File:Nf45estop.jpg|thumb|200x200px|left|E-STOP]]
<div style="clear: both"></div>

10.  Empty the cyclone dust collector.


11. Empty the main dust collector.


12. Turn off the exhaust if you are the last one in the room.
*If the air is visibly dusty, you may need to leave the exhaust running until it clears.
*Turning off the exhaust will cut power to other equipment in the room! Only turn off the exhaust if you are the last one in the room.
[[File:Nf49exhaustoff.jpg|thumb|200x200px|left|Turn off the room exhaust (if you are the last one in the room)]]
<div style="clear: both"></div>