You can switch back to visual editing at any time by clicking on this icon.
xxxxxxxxxx
==== Assembly ====
1. Place the components on a surface and clean with compressed air.
*Debris caught in the tool holder can cause the tool to slip, damaging the tool and equipment.
[[File:Nf15colletclean.jpg|thumb|200x200px|left|Clean the tool holder with compressed air]]
<div style="clear: both"></div>
2. Insert the collet into the nut.
*Put the collet on the table and the nut on top.
*Press on the nut until the collet snaps in place.
[[File:Nf16colletbuild.jpg|thumb|200x200px|left|Load the collet into the nut]]
3. Screw the collet loosely into the holder.
[[File:Nf17collettight.jpg|thumb|200x200px|left|Loosely tighten the collet]]
4. Insert the tool.
*Do not tighten on the flutes
*Make sure enough of the shank is in the collet to properly hold the tool - tool should fill ~80% of the length of the collet.
[[File:Nf18toolin.jpg|thumb|200x200px|left|Insert the tool]]
Load the collet into the fixture:
*Press and hold the top knob
*Insert the holder; rotate and push until it's fully inserted
*Shoulder must be flush with the face of the fixture
[[File:Nf19colletfix.jpg|thumb|200x200px|left|Load the collet into the fixture]]
5. Tighten the collet nut.
*Ensure all four teeth on the wrench are engaged
*Tighten the nut until the table lifts from the floor
[[File:Nf20wrench.jpg|thumb|200x200px|left|Tighten the collet nut]]
6. Load the tool into the ShopBot
*Support the holder from the bottom.
*Tool goes into the conical receptor under the skirt.
*Press the green button briefly until the tool gets sucked in.
*If the tool does not load, use compressed air to blow off the beige control box near the pillar with the air line.
[[File:Nf21loadup.jpg|thumb|200x200px|left|Load the tool]]
