Editing Instructions:Laguna JX12 ShearTec Jointer (section)

== Safety ==
'''Do''':

* Pull the locking pin before adjusting depth of cut
* Use light cuts (1/32” to 1/16” depth of cut)
* Push down and towards the fence when cutting

'''Do not:'''

* Wear loose hair, clothing, or accessories
* Allow hands to come below the top of the fence vertically or within 10 cm (4 inches) of rotating blades horizontally.
* Joint pieces less than 13 cm (5 inches) wide, 10cm (4 inches) thick, or any end grain without a push block.
* Use a table saw push block or any thin push block that can tip and drive the user’s hands into the blade.
* Joint workpieces less than 30 cm (12 inches) long and 9 mm (1/2 inch) thick.
* Change blades, blade height, outfeed table, or fence.
* Adjust the outfeed depth.

=== Emergency Stop ===
The red STOP button or the red safety bar will stop the cutterhead.