|
You will be working in the Metalworking Room . In order to keep safe from hazards created by you or other workers using any of the tools in this room, the following precautions apply in addition to any other precautions:
Safety
- Hazards: inhalation, noise, projectile, burns, laceration (sharp tools and edges), bright light/UV (welding), entanglement
- PPE: Hearing protection, eye protection at all times. Some equipment may require a respirator (P100), FRED Welding fume extractor, gloves, or other protective gear (see tool pages for more information)
for all
|
- How would one assess the "as required"? dust in the air remains after a previous member leaves, right? So how would a member know when not to use a respirator in there? I can see where Fred is only required when welding or similar, so maybe it should not be a room level precaution but specific to tools like welders? Ttenbergen (talk) 22:59, 2024 August 13 (CDT)
- Updated to clarify what is required at all times vs what may be required John Hache (talk)
- Some other equipment prohibits the use of gloves. I think this section should only have the requirement for the whole room, e.g. respirators in the woodworking room. I can't think of any hazard in this room like that, short of the facility-wide requirement to wear steel toed shoes.
|
- Most work in the metal room is hazardous not only to you but to everyone nearby. Warn others already working in the space if you're going to start producing hazardous noise, dust, light (ie welding). Don't leave hot objects unattended.
|
for all
|
- I changed that a bit, but really still not sure if it's reasonable. You may be working there and then someone else shows up and starts to work. Should you stop what you are doing and chat with them? I would not even notice they are there. So maybe the answer is, expect a hazard and wear the appropriate PPE in this space.
|
- Watch what other people are doing in case they produce an unexpected hazard.
- If doing hot works, you must keep direct watch for 60 minutes. Use an IR thermometer to check for hotspots.
|
for all
|
- If we require an IR thermometer (welding) we should probably document it as a tool and flag it as safety item not to be removed. That would also easily add it to our safety checklist. Is there actually one down there?
|
Housekeeping
- Dispose of scrap metal in the scrap metal barrels. Don't leave sharp edges poking out where they can stab someone.
|
